One beam.
Every application.
Cutting capacities, welding penetration and cleaning rates by material — the numbers behind the machine recommendation.
Laser cutting
Cutting capacity
Cutting capacity
by material and power.
Typical maximum thicknesses using oxygen (carbon steel) and nitrogen (stainless, aluminum, brass, copper) assist gas. Your material and quality requirements decide the final recommendation.
| Laser Power | Carbon Steel | Stainless Steel | Aluminum | Brass / Copper |
|---|---|---|---|---|
| 1.5 kW | 16 mm | 6 mm | 5 mm | 3 mm |
| 3 kW | 20 mm | 10 mm | 8 mm | 6 mm |
| 6 kW | 25 mm | 16 mm | 16 mm | 10 mm |
| 12 kW | 40 mm | 30 mm | 30 mm | 16 mm |
| 20 kW | 50 mm | 40 mm | 40 mm | 20 mm |
| 30 kW | 60 mm | 50 mm | 50 mm | 25 mm |
Laser welding
Joining without
Joining without
the grinder.
- Stainless steel 0.5 – 5 mm: spatter-free cosmetic seams, no post-polish
- Carbon steel and iron to 6 mm single-pass with 2000 W
- Aluminum with double-pulse mode for bright, crack-free seams
- Wire feeder bridges gaps to ~1.5 mm on imperfect fit-up
- 2–10× TIG travel speed at a fraction of the heat input
Laser cleaning
Surface prep without
Surface prep without
media or chemicals.
- Rust and oxide removal to 15 m²/h with 1500 W continuous wave
- Paint and coating stripping without abrasive damage
- Weld pre-treatment and post-weld oxide cleaning
- Mold and die cleaning with 200 W pulse — zero substrate heating
- No grit, no chemicals, no disposal stream
Tube & profile
Round, square, oval
Round, square, oval
and everything rolled.
Tube lasers cut copes, miters, slots and holes in one clamping — replacing sawing, drilling and coping with a single program.
Round tube
Ø10 – 220 mm, copes and saddle joints for handrail and frames
Square & rectangular
Furniture, racking and structural frames with clean miters
Angles & channels
L, U and special profiles with the three-chuck system
Long stock
Up to 12 m loading with follow-up support for slender tube